First Milling Machine - LC 1-1/2 VS (Bridgeport style) plus tooling. SINGLE PHASE 240VOLT 15A PLUG
Variable Speed Head: 2HP / 240 Volt / 15 AMP
Taiwanese manufacture
3 axis Fagor digital read out
Spindle Taper: NT 30
Power Feed to X Axis
Working Table Surface: 1,270mm x 230mm
Longitudinal Travel: 966 mm
Cross travel: 305 mm
Vertical travel: 406 mm
One Shot Lubrication
Coolant Pump
Chip Tray
DOM is 2007. Purchased new in 2008 from Modern tools Bayswater. It has not done a huge amount of work and is in very good condition, It has done about 15 days a year on average. ALL Tooling included, Dividing head, 2 machine vices, compound 3 axis vice, boring head, carbide cutters both solid and insert type, ER 32 chuck and 20 collet set (up to 20mm), drill chuck (with NT30 arbor) electronic edge finder, 200mm angle plate, parallels, vee blocks, clamping set, 50mm and 80mm face cutters (both with NT30 arbors) Depth Mic.
Pick up only, crane truck is strongly suggested but machine is just over 1 T so will go on 8 or 10X5 twin axle trailer if column and head are separated. (I cannot lift the fully assembled machine) The location is in NE Victoria, (closet towns Wangaratta/Benalla) I am happy to discuss any aspect of the machine. It can be inspected or tested prior to purchase.
Thank you.