AARON open to edging your 45 Degree Bevelled "Finger-Pull Door (Shark Nose)" melamine board !
using your own Edgetape
600mm length and below**
$5 +GST each piece
601mm length and above**
$8 +GST each piece
with using our ABS Edgetape (only available in white/black)
600mm length and below**
$6 +GST each piece
601mm length and above*
$9+GST each piece
Some notes to mention:
1. Edgetape width required from 29mm and greater.
2.Please provide your own edge tape/s with sufficient amount of lengths.
3.We are edging the boards as how it is received. Ensure it is straight cut, level and precise
4.Please ensure to leave the edge “raw and square, ”. Our machine does the mitre (Automatic cut the reverse bevel).
5.Please also remember to provide extra boards for testing/1-2 pcs.
Option (1)
You Edge the 3 straightedge sides initially, our process 45 degree bevelled edge (leave that particular edge in
square shape).
Option (2)
Leave all 4 sides in raw\square and in plain edge/without edge tape sticked on. Please do the marking on which
side to become the 45 degree bevelled edge.
Angle other than 45degree "The complexity". Please call in to inquire and discuss in prior.
Additional labour fee is applicable as it takes time to adjust\tuning the machine to fit that required (special) angle
i.e. for angle that is other than the 45 degree.
$30.00 surcharge if your board less than 30pcs
VIC : /
Address: 1/15 Industrial Ave Hoppers Crossing Vic 3029 (Melbourne)
NSW : /
Address: 28/115 Woodpark Road Smithfield NSW 2164 (Sydney)