PEERLESS Refrigeration Cycle 1000 LPM Air Dryer

Protecting your pneumatic equipment - We have a range of refrigeration dryers to suit your needs. Eliminate your moisture issues with Peerless.

Refrigeration dryers are a must for zero water equipment. As an air compressors pump compresses air, there is an element of heat that the air passes through. Along with this its drawing in all the moisture that's in the surrounding environment too. Once the air is compressed, it sits in the air receiver to then cool down. This is where condensate happens within the air receiver.

For example, you get your favourite canned drink from the fridge and place it on the table. The outside of the can then has water beads appearing. This is what is happening within your tank and airlines.

The best and most effective solution to prevent this happening is to employ an Air Dryer in your set up. The refrigeration air dryer cools the incoming compressed air exchanger where the outgoing air cools the incoming air. The intake air then enters an air-to-refrigerant heat exchanger where the air is cooled to 3.3 degrees celsious by the liquid refrigerant. The process causes the water vapours in the air to condense into liquid water which is then removed by the electronic auto drain fitted.

One of the contributing factors to air compressor failures is heat! Heat creates the running temperature of your air compressor to increase the oil carry over which leads into low oil levels which then can cause major pump failures and costly down time.

By maintaining your air compressor and air system will prevent a lot of future down times and costly repairs or equipment replacement. Check your air compressor oil levels, make sure there is enough cool air flow around your air compressor and no direct sun light on the air compressor system.

Installation tips:
Always install your air compressor system in a safe, cool, dry and clean area with lots of air flow
Keep system clear of rain, wind, wet/ humid and dusty areas
Do not install in an area with bad ventilation
Make sure to mount your system at least a metre away from the wall, this will also make maintenance easier!
Compressed air systems require filtration - see our filtration section for more information
Keep in Mind
When using a dryer with a Piston Air Compressor we recommend increase the air output by 2.5x as the air produced is a lot warmer than that of a Rotary Screw or Oil-Less unit. Filtration is required with refrigeration air dryers. A"PRE"filter is required for all dryers and we strongly recommend an oil / air separator for piston compressors.


Features
High efficiency condenser & evaporator
Low dew point
High quality electronic auto drain
Low in maintenance
Great Reliability


Code : WB7.5D
Compressor (W) : 350
Air in/out thread : 3/4"BSP
Piston (LPM) : 400
Screw (LPM) : 1000
Piston (CFM) : 14.2
Screw (CFM) : 35.3
Dimensions (mm) : 352x430x445
Weight (kg) : 30
Max inlet temp : 60°C
Working ambient temp : 45°C
Dew point : 3°C-10°C
Working pressure : "Min. 5 Bar
Max. 13 Bar"
Coolant : R410A
Plug : 10A