Variable Abrasive Feeder for Waterjet Cutter

Variable Abrasive Feeder
Traditonally, the garnet is delivered to the machine simply through a gravity system that is manually
controlled, therefore the adjustments are inconvenient and unprecise.

This system allows for ultra-precise automatic adjustments to the quantity of abrasive to be delivered.

On an abrasive waterjet system, the control over the abrasive flow can be
critical for a few different reasons and depending on the cutting requirements.
In particular, by precisely adjustng the garnet delivery, we allow for:

VERSATILITY: different materials may require a different amount of garnet
to cut through, with this system, you can adjust it at any time.

CONVENIENCE: traditonal feeder systems can only be manually calibrated.
The variable system is easily controlled through the software interface.

BLOCKAGES PREVENTION: especially during low pressure piercing, an
excessive amount of garnet may clog the focusing tube.

GARNET SAVINGS: the cost of the garnet, which impacts the overall costs
of operation by 50%, can be effectively managed and reduced.